PHASE X24 (English)
29
when applicable, is displayed in the box next to “External”. If no signal is available or the
connection has been interrupted, the message “--------” will be returned.
Note:
Unlike PCI cards, the PHASE X24 FW system cannot automatically synchronize the
required sample rate. Select the sample rate manually using the dropdown menu in the
Control Panel to avoid a sample rate conversion and attendant loss of quality.
Routing
In the routing section, all input signals (Wave Play 1/2, Wave Play 3/4, Analog In, Digital
In, Digital Mixer and Digital Play) can be routed to the three output pairs (Analog Out 1/2,
Analog Out 3/4, Digital Out). Almost any combination is possible. Click the three buttons
on the left-hand side to open a window in which you can select the desired pair. Needless
to say, if you intend to use the digital mixer, “Digital Mixer” must also be selected on the
input side, otherwise the signal will be sent straight to the output, bypassing the faders.
The routing options of the PHASE X24 FW
Output
The levels of the analog outputs can be controlled here. The individual sliders control the
analog volume immediately downstream of the digital-analog converter. A separate fader
is available for each mono channel. The individual channels can be joined using the
switchable stereo link function. The “Mute” buttons can be used to mute the individual
channels.
This section of the Control Panel can also be controlled completely via the Master control
on the front panel, in case you ever lose the Control Panel under dozens of overlapping
windows ;-)
