10
Always assume the tool contains fasteners. Keep the tool pointed away from yourself
and others at all times. No horseplay. Respect the tool as a working implement.
DO NOT LOAD FASTENERS with tool in compressed position to prevent unintentional firing
of trigger.
REMOVE FINGER FROM TRIGGER when not driving fasteners. Never carry tool with finger
on trigger, tool may fire a fastener if compressed.
FIRE FASTENERS into work surface only. Never into materials that are too hard to penetrate.
Never fire tool away from work surface.
DO NOT DRIVE FASTENERS on top of other fasteners, or with the tool at too steep of an
angle, the fasteners can ricochet causing personal injury.
DO NOT DRIVE FASTENERS close to the edge of the work piece. The work piece is likely to
split allowing the fastener to fly free and causing personal injury.
Avoid unintentional switching on. Ensure the On/Off switch is in the off position
before inserting battery pack. Carrying the power tool with your finger on the On/Off
switch or inserting the battery pack into power tools that have the switch on invites accidents.
Do not open the battery. Danger of short circuiting.
Protect the power tool against heat, e. g., also against continuous sun irradiation
and fire. There is danger of explosion.
In case of damage and improper use of the battery, vapors may be emitted.
Provide for fresh air and seek medical help in case of complaints. The vapors can
irritate the respiratory system.
When the battery is defective, liquid can escape and come into contact with
adjacent components.Check any parts concerned. Clean such parts or replace them,
if required.
