Standard Controller Layout
111
RangePro RPX8-P User Manual
H • Standard Controller Channel Numbers
Standard Controller Layout
Figure 55. Standard Controller Layout
Channel
Description
CH1
Yaw Control
CH2
Pitch Control
CH3
Throttle Control
CH4
Roll Control
CH5
3-position switch, usually used for flight modes.
CH6
3-position momentary switch, springs to center from both directions. Usually used for
zoom.
CH7
Momentary button, usually used for camera trigger.
CH8
2-position switch, usually used for dedicated RTL.
CH9
90-degree Rotary dial. Range of motion with center detent. Usually used for gimbal
tilt.
CH10
90-degree Rotary dial. Range of motion with center detent. Usually used for gimbal
pan.
CH11
2-position switch, assigned to Strobes
CH12
6-position rotary dial with detents at each position.
Summary of Contents for RangePro RPX8-P
