Battery Installation
43
RangePro RPX8-P User Manual
5 • Assemble RangePro RPX8-P for Flight
Figure 18. All arms unfolded
15.
Once an arm is in position, lower the arm pin into place and lightly tighten. Repeat this process for the
remaining arms.
16.
Once aircraft arms are correctly positioned, tighten the arm and pivot pins securely by hand.
The drone is assembled. Continue to section
.
Battery Installation
Installing the battery consists of the following:
•
Testing the battery charge and cell health
•
Installing the battery into the airframe (see
)
Testing the Battery
Check the battery charge and cell health of battery sides B1 and B2 as follows:
1.
Remove the battery tester (see
) from the case.
Summary of Contents for RangePro RPX8-P
