Aircraft Assembly
36
RangePro RPX8-P User Manual
5 • Assemble RangePro RPX8-P for Flight
Figure 9. Installing a landing leg
4.
Insert the landing leg into a socket on the airframe (see
) by pressing the pin so the leg can enter
the socket. Then fully insert the landing leg into the socket until the pin engages the hole (you may need to
turn the leg in the socket until the pin aligns with the hole).
Figure 10. Installing a landing leg (close-up)
5.
Repeat steps 3 and 4 to install the remaining landing leg into the other socket.
6.
On the underside of the aircraft, connect a radio antenna cable connector to one of the two radio antenna
SMA connectors located near the battery power connector as shown in
Summary of Contents for RangePro RPX8-P
