EDOC00006 - Compact NA RFID Freezer User Manual, rev 8
14
Maintenance
There are no user serviceable parts in the freezer. Please contact Terso
Solutions for any service related inquiries.
WARNING
Always disconnect the power supply to the freezer prior to any
repair or maintenance
in order to prevent shock or injury.
Cleaning
Use a dry cloth to wipe off small amounts of dirt on the outside and inside of
the freezer and all accessories. If the outside panels are dirty, clean them with
a diluted neutral dishwashing detergent. (Undiluted detergent can damage the
plastic components. For the dilution refer to the instruction of the detergent.)
After cleaning with diluted detergent, always wipe off the same areas with a
wet cloth. Then wipe off the freezer or accessories with a dry cloth.
Never pour water onto or into the freezer. Doing so can cause electric shock or
short circuit.
Do not clean the freezer with scrubbing brushes, acid, thinner, solvents,
powdered soap, cleanser or hot water. These agents can scratch the paint or
cause it to peel. Plastic and rubber parts can be easily damaged by these
materials. Especially never use any volatile solvent to clean the plastic or
rubber parts. When a neutral dishwashing detergent is used to clean the
freezer, wipe it up thoroughly with a cloth soaked in clean water.
Troubleshooting
If the freezer appears to not be operating correctly, check to ensure that it is
plugged in to a wall outlet and powered on. If further support is needed,
contact Terso Technical Support at +1 (888) 376-0257 in the US or +49 621
8501 233 in Europe. Support can also be contacted by visiting
http://support.tersosolutions.com
Disposal
Terso Solutions will handle the disposal of the freezer and its components.
Please contact Terso Solutions at +1 (888) 376-0257 in the US or +49 621
8501 233 in Europe to arrange for freezer disposal.
