©2012 Terumo BCT, Inc.
Page 14 of 14
PN 306620452
Inserting the wafer disposal box
1
Insert the lower edge of the disposal box into the front of the TSCD II
device.
2
Push the box into the device until it locks into place.
Note:
The TSCD II device has two photo sensors that align with the slots
on the wafer disposal box when it is inserted properly. The photo sensors
send a message to the LCD display when the box needs to be emptied.
However, if the box is not inserted properly, the photo sensors will not
work as intended; wafer jams or incorrect fill detection may occur.
Setting Parameters
Refer to section 6.7 of the operating instructions.
