©2012 Terumo BCT, Inc.
Page 3 of 14
PN 306620452
Operating Procedure Flow Chart
Turn on the power.
The LCD illuminates, the self-check starts, and the device beeps.
Open the clamp covers.
Press the RESET button to realign the clamps and advance the next wafer (if applicable).
Place the tubing in the clamps.
Tubing lengths must extend a minimum of one inch beyond the outer edge of both clamps.
Close the clamp covers.
Press the START button to initiate the welding cycle.
After the device beeps and the message
WELD COMPLETE/OPEN CLAMPS
appears
on the LCD display, open the clamp covers.
Remove the welded tubing and rotate it 360° while visually inspecting it.
Pinch the weld site to open the tubing and inspect the weld.
Remove and discard the waste segments.
Note:
This Operating Procedure Flowchart is not intended to replace the procedures provided in the
current TSCD II operating instructions.
