23
Preparation
Attaching/Detaching a Pole Clamp
Attach the pole clamp
The pole clamp can be locked at the pole clamp lock portion only in the direction shown in the figures below.
To attach to a vertical pole
•
Insert the pole clamp along the grooves on the back of
the infusion pump from the lower side.
Check
• The pole clamp must be securely inserted. The pole clamp lock portion
should make a click when the pole clamp is attached.
Note
• For instructions on attaching the IV Pole and other parts, see page 24.
To attach to a horizontal pole
Notes
• The pole clamp can be attached in the vertical direction as shown in the
figure. Note that the pump cannot be installed in the rack system when the
pole clamp is attached in the vertical direction.
• A pump with an RS-232C connector cover (TE-LF632 only) may produce
difficulties attaching to some horizontal bars depending on the diameter of
the bar. (It can be installed on to “Horizontal Rail”.)
• Do not attach the pump in the vertical direction.
Detach the pole clamp
Pole clamp lock portion
•
Pull the pole clamp downward while pressing and
holding the pole clamp lock portion (green lever at the
bottom of the pole clamp).