24
Mounting options
The monitor is commonly mounted to a cross bar in an enclosure, the crossbar having a 100mm x
100mm standard VESA mount hole pattern. It may also be panel mounted using the included bracketry.
A tapered foam surround gasket, thinner at the rear than at the front, compresses as the
monitor is pushed into the front of the panel opening. The correct panel opening dimensions
are 519 mm x 314 mm with corner radii of 9.5 mm (all dimensions plus or minus 0.2 mm).
VESA Mount
The monitor has an integral VESA standard mount pattern that conforms to the “VESA Flat Display Mounting
Interface Standard” which defines a physical mounting interface and corresponds to the standards for monitor
mounting devices.
!
Warning
Please use the correct screws! The distance between the back cover surface and the bottom of the
screw hole is 8 mm. Please use four M4 diameter screws with 8 mm length to mount the monitor.
!
Mise en garde
Veuillez utilizer les vis correcte! La distance entre la surface du capot arrière et le fond du trou de vis
est de 8 mm. Veuillez utilizer quatre vis de diamètre M4 d’une longueur de 8 mm pour mounter le
moniteur.