- 8 -
Figure 9
Now look at the bubble level. The bubble should be fully inside the red circle.
If it is not, wind direction, speed, and rain readings may not operate
correctly or accurately. Adjust the mounting pipe as necessary. If the bubble
is close, but not quite inside the circle, and you cannot adjust the mounting
pipe, you may have to experiment with small wooden or heavy cardboard
shims between the sensor package and the top of the mounting pole to
achieve the desired result (this will require loosening the bolts and some
experimentation).
Make sure you check, and correct if necessary, the northly orientation as
the final installation step, and now tighten the bolts with a wrench.
6. Reset Button and Transmitter LED
Using a bent-open paperclip, press and hold the RESET BUTTON (see
Figure 10) to affect a reset: the LED turns on while the RESET button is
depressed, and you can now let go. The LED should then resume as
normal, flashing approximately once every 48 seconds.
RESET
button
LED light
Summary of Contents for WS1081
Page 26: ... 26 4 1 4 Click Language button enters the Language menu 4 2 Record option ...
Page 36: ... 36 5 1 Setting option Please refer to 4 1 1 5 2 Alarm option Please refer to 4 1 2 ...
Page 37: ... 37 5 3 Max Min option 5 4 History option Please refer to 4 2 1 ...
Page 38: ... 38 5 5 Graph Please refer to 4 2 2 5 6 Upload option Please refer to 4 3 ...