The pilot light will turn ‘OFF’ when the indicated setting reaches
the correct temperature. The iron is now ready for use. During
use the indicator will come on and off as the thermostat main-
tains the iron at the correct temperature setting.
Steam Ironing
Steam Ironing should be car-
ried out at the highest settings
on the temperature dial.
The quantity of steam is regu-
lated by the
Steam Control
.
Move the steam selector to a suitable position depending on the
quantity of steam required and the ironing temperature.
Warning:
the iron gives
off steam continuously
only if you hold the iron
horizontally. You can stop
the continuous steam by
placing the iron in a ver-
tical position or by mov-
ing the steam selector to
the “
0
” position.
Shot of Steam
This feature may be used
during steam or dry iron-
ing but only when the
iron is at highest settings.
Press the Shot of Steam
button to release a surge
of steam. You may need
to press the button a
few times to prime the
system.
Wait a few seconds for the steam to penetrate the fabric before
pressing the button again.
Use no more than 3 bursts at any one time.
Excessive use of this feature will cause the iron to cool, and the
pilot light will illuminate. If this happens, wait for the pilot light
to go out before using the feature again.
Vertical Shot of Steam
Warning:
DO NOT allow anyone to come near you during this
process. NEVER allow steam to get anywhere near your body or
clothing or apply steam to clothes or fabrics that are being worn
by human or pets.
DANGER OF SCALDING.
Hold the iron facing away from you at all times. DO NOT OVER-
REACH or operate the iron while standing on a ladder etc.
Method:
Set the iron to its highest tem-
perature and wait for the pilot
light to go out.
Set the iron vertical. Hold the
iron away from you and 15 – 30
cm from the garment.
Press the Shot of Steam But-
ton once. Steam will penetrate
into the garment removing the
wrinkles.
For stubborn wrinkles:
set the iron back on its stand and
wait a few seconds. Repeat the procedure once more. Most
wrinkles can be removed within three presses.
Spray Button
Press the spray button to
spray water on the ma-
terial. It may be used for
steam or dry ironing.
Note:
To avoid staining,
do not use the spray on
silk or synthetics, and be
careful when you iron
delicate fabrics.
Note:
For Spray and Shot of Steam functions to operate, the
water tank must be at least one-quarter full. If these features
stop working place the iron on its stand and fill the water tank.
During Ironing:
In between operations always stand the iron
on its heel. NEVER leave the iron face down.
Maximum
Off
IR1914 Steam Iron User Manual
After you have finished ironing:
Set the steam control to minimum. Switch the iron off at the
mains and unplug. Stand the iron on its heel and let the iron cool
down fully.
Now invert the iron,
open the filler and pour
away the excess water
from the tank.
When pouring away the
water, gently shake the
iron to remove any loose
particles from the tank.
Cleaning
Unplug the iron from the mains and allow it to cool down fully.
To remove starch or other deposits from the soleplate, apply a
small amount of mild cleaner to a damp cloth, forming a paste
on the cloth. Gently rub the soleplate, then wipe with a moist
cloth. The body of the iron may now be cleaned with a barely
damp cloth and then dried thoroughly. Do not wet the appli-
ance body, cord or mains plug.
CAUTION:
Never use scouring pads, abrasives or harsh cleaners
on the iron body or the soleplate.
Auto Cleaning:
This function removes the scales and minerals
built up in the Steam Chamber. The iron will remain in the best
condition if this function is performed at least once a month or
more regularly depending on the hardness of the water.
1. Half-fill the water tank. Stand the Iron upright on its stand.
3. Set the steam control to ‘
0
’. Turn the Temperature Dial to its
maximum setting.
5. Plug the iron in and switch on. Wait until the iron is hot
and the pilot light goes off. Allow the pilot light to come on
and go off a second time.
7. Turn the Temperature Dial to minimum and
8. Unplug the iron from the mains supply and hold the iron
horizontally over a sink.
10. Move the steam control to the position and hold it.
Steam and boiling water
will drain from the holes
on the soleplate wash-
ing away built up debris
and scale.
Keep skin and body away from hot water - DANGER OF SCALDING!
11. Gently shake the iron until no more water comes out.
12. Now release button and set the iron back on its heel.
11. When cool, wipe the soleplate clean with a soft cloth
Storage
When not in use the iron should be securely stored out of the
reach of children. Store the iron on its heel with the cord loosely
looped around the body. Do NOT store the iron on its soleplate
or you may damage the finish.
Warranty
Your TESCO iron is covered by a warranty for 12 months from the
date of purchase. If a fault develops during this period, please
return the unit to your nearest Tesco store together with the
original receipt as proof of purchase. This warranty in no way
affects your consumer rights.
Specifications
Voltage Rating: 220 -240V AC, 50Hz
Power Consumption: 1500-1900W
Net Weight: 0.96kg
UK: Waste electrical products should not be disposed of with
household waste. Separate disposal facilities exist,
for your nearest facilities. See www.recycle-more.
co.uk or in-store for details.
ROI: Produced after 13th August 2005. Waste
electrical products should not be disposed of with
household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for
recycling advice.
IR1914 Steam Iron User Manual
IR1914
Steam Iron
