background image

Important Safety Information

To reduce the risk of fire, injury or electrical shock:

Read all the instructions before operating the 

pump station and keep them for future reference. 

If you pass  the product on to a third party, in-

clude these instructions.
Unplug the appliance from the mains when not 

in   use, and before emptying or cleaning.
Unwind and straighten the power cord and the 

iron supply cord before use.
Do not touch the soleplate of the iron if it is hot. 
Always hold the iron by the handle.
Keep the iron well away from surfaces and ob-

jects that can be damaged by heat. 
Ensure there is adequate room to operate the iron.
Ensure that the iron or base cannot fall into water.
Do not immerse the connecting cord in any  

liquid.
Do not let the connecting cord overhang the 

edge of the work surface or allow it to touch hot 

surfaces or sources of heat or flame. 
If any part of this appliance is damaged or mal-

functions in any way, or the power cord, mains 

plug or the iron supply cords are broken do not 

use it. The service agent or similarly qualified 

person must replace it in order to avoid a hazard.
NEVER leave the iron face down. Stand it on the 

rest on the steam station base or on the iron rest 

of an ironing board.
ALWAYS ensure that the steam station base is 

placed on a firm and level surface before use. 

The surface must be strong, waterproof and large 

enough to support the entire steam station.
Do not use outdoors or in damp or wet conditions.
Do not use this appliance for professional laundry. 
Do NOT use this appliance for any purpose not 

covered by the instructions.
Use caution when turning the iron upside down, 

there may be residual hot water in the iron.  
Observe all ironing instructions and temperature 

dot settings given by the garment manufacturer. 

These are normally on a label or  labels inside the 

garment.
This appliance can be used by children aged from 

8 years and above and persons with reduced 

physical sensory or mental capabilities or lack 

of experience and knowledge if they have been 

given supervision or instruction concerning use 

of the appliance in a safe way and understand 

the hazards involved. 
Children shall not play with the appliance. 

Cleaning and user maintenance shall not be 

made by children unless they are older than 8 

and supervised .
Keep the appliance and its cord out of reach of 

children less than 8 years. 
This appliance must not be left unattended while 

it is connected to the supply mains.
Do not use the appliance if it is dropped, has  vis-

ible signs of damage or is not watertight.

ELECTRICAL INFORMATION

Before using this appliance ensure that the volt-

age of your electricity supply is the same as that 

indicated on the appliance.

BURNS CAN OCCUR FROM TOUCH-

ING HOT METAL PARTS, HOT WATER 

OR STEAM. EXERCISE CARE WHEN 

HANDLING THIS APPLIANCE!

THIS APPLIANCE MUST BE EARTHED

Page 2

Summary of Contents for IRSG2416









Reviews: