Vertical Steam
•
Select the Steam level and wait for the selector to stop flashing.
•
Set the iron to its highest temperature and wait for the pilot light
to go out.
•
Set the iron vertical. Hold the iron away from you and 15 – 30 cen-
timetres from the garment.
•
Press the Steam Button for a few seconds. Steam will penetrate
into the garment removing the wrinkles.
•
For stubborn wrinkles: Wait a few seconds. Repeat the procedure.
Most wrinkles can be removed within three presses.
•
Warning: DO NOT allow anyone to come near you during this pro-
cess. NEVER allow steam to get anywhere near your body or cloth-
ing or apply steam to clothes or fabrics that are being worn by
humans or pets. DANGER OF SCALDING.
•
Hold the iron facing away from you at all times.
•
DO NOT OVERREACH or operate the iron while standing on a lad-
der etc.
•
Make sure that the power cord and the iron cords remain slack and
that there is no danger of overturning the steam station base.
CONTROL PANEL WARNINGS AND ACTIONS
Low Water Level Indicator
If the water in the tank is too low, the low water level indica-
tor will illuminate. You will hear two beeps and the steam
generator will shut off. You must now refill the water tank
and reset the appliance.
After refilling the tank, press the Reset Button once to ex-
tinguish the low water level indicator. You can now release
steam for ironing
Descaling Indicator
If the mineral deposits in the anti-calc filter have reached a
high level the descaling indicator flashes and will continue
to flash until the anti-calc filter is replaced.
1. Depress and hold the On/Off button to switch the appliance off.
2. The anti-calc filter is in the base. Grasp the anti-calc filter and re-
move it from the housing following the procedure on Page 4. Dis-
pose of the used filter at a recycling centre.
3. A replacement anti-calc filter is provided. Unwrap the filter and
place it for two minutes in clean water before inserting it in the
steam station.
4. Switch the appliance on with the On/Off button.
5. If the descaling indicator stays on after replacing the filter, press
the Reset button to reset the unit before resuming operations. If
the indicator still stays on, switch the unit off. Remove and re-fit
the filter before switching on and resetting the unit again.
Do not operate the iron with an ineffective anti-calc filter, or
without a filter. The pump action of the appliance will be im-
paired and the steam function could fail altogether.
If you live in a hard water area, using demineralised or dis-
tilled water will prolong the life of the anti-calc filter.
Page 7