13
USER MANUAL
AVR
11
• 1/1 • 1-500 kVA • Automatic Voltage Regulator
14
3.5. 1 KVA -50 KVA (1 Phase Input/1 Phase Output) Connection of Terminals
Connection terminals of the AVR located at rear side. Remove the rear cover with an
instrument.
After removing the cover, route the earth, input and output cables through holes located
below cable connection points.
Image-3
Feedback Risk
Firstly, separate the AVR from the circuit. Measure all terminals
including the earth connection (PE) and check if there is dangerous
voltage.
Check the AVR’s input, output fuses and Mains Automatic Fuses
are in the OFF position before connections of output.
Before installation, make sure that all circuit breakers in the panel
are in the "OFF" position.
