10
2.3 STATUS Messages
This message group simply shows the UPS STATUS at the upper line of LCD PANEL.
RECTIFIER START !
:
UPS started the rectifier
ENTER START :
Press ENTER to start the UPS.
INVERTER START !
:
UPS started the inverter.
MAINT SWITCH ON !
:
Maintenance bypass switch is on
STATUS NORMAL !
:
UPS is operating.
EMERGENCY STOP !
:
External emergency stop signal is applied to UPS.
WAITING SYNC !
:
Inverter started waiting for mains synchronization.
STATUS FAULT !
:
Fault status
RECTIFIER START :
At start up the UPS controller board checks for input voltage,frequency,battery voltage for starting,if these
parameters normal, UPS starts.
INVERTER START :
If the inverter stops from any reason, controller board tries to start inverter again,during inverter start this
message appears on first line of LCD PANEL
MAINT SWITCH ON:
Maintenance bypass switch is connected from input to the output of UPS directly.
İ
f the maintenance bypass
switch is on (1 position) controller stops inverter for accidental short circuits between mains voltage and in-
verter output. If the user turn off maintenance switch inverter starts again.
EMERGENCY STOP :
If an external EPO switch is installed to system (connected to interface board),to stop all UPS parts (rectifi-
er,static bypass,inverter,etc….) is possible. After pressing EPO switch all parts of the UPS stops,for restart
turn off S1 (inverter input) switch and turn on again.
FAULT STATUS :
In some cases controller checks events but can not find solutions, in this case controller decide to stop sys-
tem, for restart user must turn off S1 (inverter input) switch and turn on again.
2.4 SHUTDOWN MESSAGES :
XA200P series UPS’s can operate interactive with operating system, you can send commands to UPS from
operating system by using some softwares.UPS takes this commands and produces some messages these
are:
WAITING SHUTDOWN
: Shutdown command is performed from operating system and UPS is waiting
for a certain delay for shutdown.
UPS SHUTDOWN
: UPS is in shutdown status
WAITING RESTART
: UPS is shutdown but it is waiting for a certain delay for restart
PAR.SHUTDOWN
: In parallel system the other UPS send shutdown command and UPS is in
shutdown status
.
CANCEL SHUTDOWN
: Shutdown command is cancelled.
Only operating system or a PC computer can send this commands.
If the shutdown command is performed during line failure UPS shutdowns and is the mains is okay UPS starts
again automatically.
