4
/
Cleaning during the juicing process
If necessary, clean the stainless steel mesh after preparing about 500 ml juice (container
for juice filled up to the top mark). Remove the tube by rotating it clockwise (reverse thread)
and closure of the juicing chamber and remove the stainless steel mesh . Wash these
three parts under running water and rid them of any attached pulp, seeds, etc. . After
cleaning, put the stainless steel mesh, closure of the juicing chamber and tube back into
place and continue juicing.
Cleaning
Disassemble and clean the juicer after each use. Remove the tamper and reservoir , press
the handle lock and remove the handle . Remove the tube and closure of the juicing
chamber by rotating clockwise (reverse thread). Remove the stainless steel mesh and auger .
Pull out the sealing ring from the juicing chamber by pressing on the central part .
Remove the silicone seal from the closure of the juicing chamber .
Clean the juicer – all parts except for the base with juicing chamber, handle and metal clamp
are
dishwasher safe
. After cleaning, assemble the juicer again in reverse order.
Notice:
When attaching the sealing ring and stainless steel mesh, make sure that both parts fit
into the indent inside the chamber ( , ); if needed, use a suitable object to put the sealing
ring properly in place.
Storage
Store the juicer assembled; if needed, first remove the reservoir with tamper, the handle
and the tube to save space. Store the container for dry pulp inserted in the container for juice
with the lid on .
