11
ENG
The bottom surface and the power cord of the hob are not accessible after installation.
Yellow / Green
Black
Brown
Blue
Yellow / Green
Black
Brown
Blue
1. If the cable is damaged or needs replacing, this should be done by an after-sales technician using the proper tools, so as to
avoid any accidents.
2. If the appliance is being connected directly to the mains supply, an Omni polar circuit breaker must be installed with a
minimum gap of 3mm between the contacts.
3. The installer must ensure that the correct electrical connection has been made and that it complies with safety regulations.
4. The cable must not be bent or compressed.
5. The cable must be checked regularly and only replaced by a properly qualified person.
1. The ceramic cooker hob must be installed by qualified personnel or technicians. We have professionals at your service.
Please never conduct the operation by yourself.
2. The ceramic cooker hob should not be mounted to cooling equipment, dishwashers and rotary dryers.
3. The ceramic cooker hob should be installed such that better heat radiation can be ensured to enhance its reliability.
4. The wall and induced heating zone above the work surface should withstand heat.
5. To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
6. A steam cleaner is not to be used.
The power supply should be connected in compliance with the relevant standard, or a single-pole circuit breaker. The method of
connection is shown below.
Cautions
Connecting the hob to the mains power supply
