Model S/X Wireless Charger
The Model S/X wireless phone charger can charge your Qi-enabled smartphone at up to 7.5W of power
for Model S/X. Once installed, simply push on the center console rear bin lid to open and place your
smartphone in the phone charger, which is located on the back of the bin cover. The wireless phone
charger uses one of the front USB ports to charge.
Installing Wireless Phone Charger
To install:
1.
Open the rear bin storage area in the center console. This area is the storage portion closest to the
cup holders, where the 12V power socket and USB ports are located.
2.
Remove the rubber mat from the bottom of the console.
3.
Lower the wireless phone charger onto the back of the console storage cover while open. You will
hear a snap when it has secured tightly.
4.
Locate the USB ports and insert the charger into either port.
5.
Route the wire through the wiring indent and ensure the wire does not stick up.
6.
Reinstall the plastic mat in the center console.
7.
Place your smartphone into the wireless phone charger. It should fit snugly and will automatically
start charging.
Model S/X will charge your smartphone only when the vehicle is powered on (i.e., the touchscreen is on,
and you are in your vehicle). You smartphone will not continue to charge if you leave it plugged in after
exiting the vehicle. Model S/X will not charge your smartphone if the vehicle’s battery is discharged.
NOTE: The wireless phone charger many not work if your phone case is too large or made of medal. Take
the phone out of the case and place the phone on the charger.
