13
ENG
Position The Appliance
Position the appliance in the desired location. The back should rest against the wall
behind it, and the sides, along the adjacent cabinets or walls. The dishwasher is equipped with water supply and
drain hoses that can be positioned either to the right or the left sides to facilitate proper installation.
Levelling the appliance
Once the appliance is positioned for levelling, the height
of the dishwasher may be altered via adjustment of the
screwing level of the feet.
NOTE
Only apply to the free standing dishwasher.
Free Standing Installation
Fitting between existing cabinets
The height of the dishwasher, 845 mm, has been
designed in order to allow the machine to be itted
between existing cabinets of the same height in
modern itted kitchens. The feet can be adjusted so
that correct height is reached.
The laminated top of the machine does not require
any particular care since it is heatproof, scratchproof
and stain proof.
Underneath existing work top
(when itting beneath a work top)
In most modern itted kitchens there is only one single work top
under which cabinets and electrical appliances are itted. In this
case remove the work top of the dishwasher by unscrewing the
screws under the rear edge of the top (a).
ATTENTION!
After removing the work top, the screws MUST BE screwed in
again under the rear edge of the top (b).
The height will then be reduced to 815 mm, as designated by
the International Regulations (ISO) and the dishwasher will it
perfectly under the kitchen working top.
Built-In Installation (for the integrated model
Step 1. Selecting the best location for the dishwasher
The installation position of dishwasher should be near the existing inlet and drain hoses and power cord.
Illustrations of cabinet dimensions and installation position of the dishwasher.
