Tiger Shark Operation Instruction Manual
http://tesoro.com/TigerShark_Manual.htm
2 sur 15
21/06/2007 14:32
1 Upper Pole Assembly
Fully assembled, including upper pole stem with handle grip, padded arm bracket, and pole lock.
1 Control Housing With Headphones Attached
1 Middle Pole Assembly With Pole Lock
1 Lower Pole Assembly
Fully assembled with 2 washers and nylon nut and bolt.
1 8" round open center concentric searchcoil with 8' cable
1 8-cell battery pack with 8 AA batteries installed
1 Tube of Dow Corning #4 silicone
2 Velcro cable straps
1 Operator Instruction Manual
1 Tesoro Warranty Card
If any of these items are missing, contact the Tesoro Authorized Dealer where you purchased your
detector
immediately.
ASSEMBLING YOUR DETECTOR
1) On the lower pole assembly, remove the mounting screw
and thumb nut from the black nylon pole tip.
2) Insert the pole tip between the mounting ears of the
searchcoil and align the holes of the pole tip and washers with
those of the mounting ears.
Note: The pole tip should fit very snugly into the mounting
ears.
3) Insert the mounting screw through the holes in the mounting
ears and pole tip entering from the side opposite the cable
connection.
4) Install the thumb nut on the mounting screw and tighten by
hand.
Note: Do not overtighten the thumb nut. It should be snug, but not too difficult to loosen up.
5) On the middle pole assembly, depress the two spring buttons and slide the middle pole assembly into
the upper pole assembly until the spring buttons click into the holes, thus locking the two assemblies into
place. Tighten the pole lock to secure the two assemblies together.
