28
W A R N I N G
Check for the location of the test lead set at current test mode. Place
the red lead at mA only for below 400mA, and place it at 10A when the
value to be tested is over 400mA, or the value is unknown.
W A R N I N G
Use it only for the current measuring after checking for the test mode.
Especially, after the current mode is selected, there may occur
burnout of fuses, damage, or breakdown of the system when the
voltage is measured.
27
◉
PTZ CONTROLLER
•
How to connect each terminal and LCD screen
PTZ Operation Test : The basic operation of PTZ : Up, Down, Left, Right,
and Zoom, and Manual focus controlling are possible, also. The test of
various protocols and transmission speed are possible. In order to control
PTZ, connect the PTZ communications cables to TX terminal of
RAPPORT337.
- PTZ Control Setup Screen
ADD Setup Screen Protocol Setup Screen Communications Speed
Setup Screen
