4
W A R N I N G
◉
Battery Charging & Its Precautions
With the rechargeable 6 nickel hydrogen
(Ni-MH) AA-size batteries placed in,
Rapport337 can be charged with an
adopter of above DC 12V, 1A, and it
takes more than 8 hrs for the battery to
be fully charged.
The battery operates normally after initial
2 or 3 times of full charging, and it can be
used for about 4 hrs and above.
The battery charging can be checked on
the initial picture of POWER ON, and
also confirmed on the VIEW INFORMATION.
The battery is recharged when connected
to a DC adopter irrespective of the Power
slide S/W or button.
Alkaline battery(AA size) is usable for
about 2 hrs.
3
W A R N I N G
◉
Pay attention to the following precautions when using
Rapport337.
•
Do not use the unit in damp humidity or leaking gas environments.
•
Do not touch it with wet hands.
•
Be mindful not to shock or shake the unit while in use to avoid
damage.
•
Avoid the places of strong magnetism or electric wave, which
would cause incorrect measuring.
•
Be careful not to expose the ports or joints to dirt or liquid.
•
Make sure to use specified replacement fuses described in the
3rd chapter.
•
Do not disassemble the Rapport 337.
•
Do not use the meter function, when the Rapport337 or the lead
set look damaged.
•
Do not measure resistance when the power is applied to a circuit.
•
When using the meter function, do not forget to turn on the power
of Rapport337 and set up the proper measurement mode before
connecting to a circuit to be measured.
•
Turn off the power to the circuit to be measured and discharge all
high voltage capacitance before starting resistance or continuity
tests to avoid damage to the Rapport 337.
•
Put the finger behind the protecting pad when using a probe.
