Chapter 5 – Composer Software
Page 50
TestEquity 101H Temperature/Humidity Chamber
Creating and Editing Profiles in Composer Software
This section describes the features of the Profile View in Composer Software and includes
instructions for using it. A profile is a set of instructions consisting of a sequence of steps. When
a profile runs, the controller automatically executes its steps in sequence.
Profile View Orientation:
Describes the layout of the profile screens.
Profile Parameters:
Settings that apply to a profile.
Step Parameters:
Settings that apply to a step.
Opening the Profile View:
Displays the list of profiles in the device.
Creating Profiles:
Up to 50 profiles can be created.
Saving a Profile:
Store profiles on the computer to make it easy to load them in other controllers
or to restore one that was inadvertently changed or deleted from the controller.
Loading a Profile:
Loads a profile that was previously saved to the controller’s memory.
Duplicating a Profile:
An easy way to create a new profile similar to one that was created
previously.
Deleting a Profile:
Removes unneeded profiles from the controller memory freeing up space for
new profiles.
Opening the Step Editor:
Displays the details of the step.
Adding Steps:
Up to 50 steps can be included within any given profile.
Inserting Steps:
Create a new step at a specific point in a profile.
Deleting Steps:
Remove a step from a profile.
Password Protect a Profile:
Avoid unwanted and inadvertent changes to a profile with
password protection.
Changing or Removing a Password from a Profile:
When password protection is no longer
needed it can be easily removed.
