Instructions for use
Probe ppipe ccan bbe bbent (
),
but not kinked
(
).
Do nnot uuse fforce
Technical data
Measurement range:
Up to 500 °C
Outer diameter of probe pipe:
10 mm
Probe pipe length:
330 mm
Max. immersion depth:
280 mm
Minimum bending diameter (
):
140 mm
Cleaning the flue gas probe
Unscrew probe pipe at the screw connection and remo-
ve pipe.
Place probe pipe in hot water and move the probe pipe
around. Blow air through pipe or clean with a round
brush (e.g. made of brass).
Change thermocouple
Pull out the bending protection spring from the guide at
the back outlet with a counter-clockwise movement and
pull off the tubing.
Remove the thermocouple from tthe pplastic cclip using a
screwdriver.
Do nnot ppull oon tthe tthermocouple ccable!
Pull bending protection spring over the thermocouple
and remove the thermocouple cable from the slit hose.
Apply lubricant e.g. grease to the O ring before installing
a thermocouple in order to avoid damage.
When inserting the new thermocouple press on the pla-
stic clip but not on the thermocouple cable.
testoterm
testoterm
testoterm
testoterm
tes
to
term
m
miinndd..
114400 mm
m
m
Flexible flue gas probes 0600.9430 / 0600.9440
