4 Using the product
13
Configuring several data loggers with the same settings
Existing configuration data can be stored on the PC and copied to
other data loggers.
The configuration file must be available in XML data format, you
can select any file name.
> Copy an existing configuration file to the data logger.
Changing the logo for the measurement data report
A logo is inserted in the measurement data report. This can be
customised.
The logo must be available in JPEG data format, the file size
should not exceed 5 kB and the file name must be
Logo.jpg
.
> Create a logo that meets the above criteria and copy it to the
data logger.
Configuring the data logger using Testo PC software
Alternatively, the data logger can also be configured using testo
Comfort Software Professional (version 4.3 service pack 2 or later)
or testo Comfort Software CFR (version 4.3 service pack 2 or later).
Please consult the relevant software instruction manual.
4.2.
Measuring
Starting measurement
Depending on the configuration of the data logger, the
measurement program is started via one of the following criteria:
• Button Start: hold down the
START
key for > 3 seconds.
• Time Start: the measurement starts automatically once the
configured time has been reached.
- The logger switches to
Rec
mode, the
Mode
status LED flashes
green.
Setting time marks
While the measurement program is running (
Rec
mode), up to
10 time marks can be set. These are used to document the transfer
of responsibility, for example.
> Hold
down
the
START
key for > 3 seconds.
- The number of set time marks is displayed for 3 seconds and
flashes three times (instruments with display), Mode status LED
flashes green/red three times.
Ending measurement
Depending on the configuration of the data logger, the
measurement program is ended via one of the following criteria:
Shop for Data Logging products online at:
www.
DataLoggerStore
.com
1.888.610.7664
