17
Memory settings
Reading or printing memory
OUT
1. Reading out or printing memory contents:
If the “OUT” display is flashing and the
button is pressed,
printing of the complete memory contents is started. Cancel
printout by pressing the
button.
2. Selecting the location:
If
is activated selection options appear in the display to select
the required location. Select location by pressing
.
If printing is activated by pressing
at this point,
all
of the logs
(measurement series and cycles) for this location are printed.
Cancel printout by pressing the
button.
3. Selecting the log:
Confirm the location selected above by pressing
.
The M.0x counter flashes in the display.
Select the log no. by pressing
.
activates a printout of the selected measurement log.
Press
to display the values measured.
Cancel printout by pressing the
button.
4. Select the measurement cycle
(only possible if a
measurement log consists of a measurement series)
:
Confirm the measurement log selected above by pressing
.
The N.0x counter flashes in the display.
Select the measurement cycle by pressing
.
activates a printout of the selected measurement cycle.
The
button enables you to go back one step.
E
ES
SC
C
L
Lo
oc
ca
at
tiio
on
n
01:13
1998
M.0
5
5
N.0017
Museum
01.01
824
M.05
5
N.00
117
7
Lux
824
Lux
M.05
5
N.0017
O
OU
UT
T
CLEAR
MEMORY
0011
Location
Duct 1
ESC
Location
ESC
Location
ESC
Location
ESC
Location
ESC
Location
Press the
button to access the memory settings
mode. Confirm flashing save symbol
via the
button.
Cancel printout by pressing the
button.
i
1.888.610.7664
info@Testo-Direct.com
www.
Testo-Direct
.com
