10
CAUTION:
Do not store the tool in a cold weather environment to prevent frost or ice formation
the tools operating valves and mechanisms that could cause tool failure.
PLACEMENT OF NAIL:
Metal connector nails are not designed to penetrate metal. When installing metal connectors,
always place the exposed point of the metal connector nail into the metal connector’s
pre-formed hole, and orient so the nail is perpendicular to the hole before attempting to drive
a fastener.
Operation in Hot Weather
Keep tool out of direct sunlight as excessive heat can deteriorate bumpers, o-rings and other
rubber parts resulting in increased maintenance.
Operation in Cold Weather
When operating tools at temperatures near and below freezing, the moisture in the air line
may freeze and prevent tool operation.
1. Reduce the air pressure to 80 psi (5.5 bar) or less.
2. Removed all fasteners from magazine.
3. Connect air and free-fire (blank-fire) the tool. Slow
speed operation tends to warm up the moving part.
Correct placement of nail
Incorrect placement of nail
Summary of Contents for BN3438JH
Page 12: ......
