ZEUS 3.0 (MADE IN EUROPE)
~ 22 ~
TESUP
7.5 ELECTRICAL CONNECTIONS:
▪
Connect a three-wire cable with a suitable cross-section (refer to Table 9 /
Table 10) and the required length to the generator.
▪
Make the electrical connections as shown in Fig. 1:.
▪
Connect the charge controller and the transformer as shown in the
▪
connection diagram (refer to the relevant documentation).:
Distance between generator
and charge controller [m]
<11 m <18 m <29 m
<44 m
<68 m
<110 m
Cross-section
2.5 sq.
mm
4 sq.
mm
6 sq.
mm
10 sq.
mm
16 sq.
mm
25 sq.
mm
CABLE DETAILS 24V
Distance between generator
and charge controller [m]
<11 m <18 m <29 m
<44 m
<70 m
<113 m
Cross-section
2.5 sq.
mm
4 sq.
mm
6 sq.
mm
10 sq.
mm
16 sq.
mm
25 sq.
mm
CABLE DETAILS 48V
WARNING:
All work on electrical equipment must be carried out by a qualified
electrician with the power switched off!
NOTE:
To ensure proper operation, you must use an original TESUP charge
controller
.
Summary of Contents for ZEUS3.0
