ZEUS 3.0 (MADE IN EUROPE)
~ 23 ~
TESUP
▪
Feed the three-wire cable through the tower right up to the top.
▪
Provide suitable strain relief.
▪
Connect the wires to the generator
▪
Short circuit all 3 phases to activate the generator brake.
▪
Pull a suitable shrink tube over each wire of the cable
▪
Twist and solder each wire of the cable to the wire from the generator
▪
Pull heat shrink tubing over the solder joint and shrink.
▪
Wrap each wire with textile insulating tape
7.6 ERECTING THE WIND TURBINE:
▪
Attach the wind turbine to the tower. Be careful not to damage the cable.
▪
Screw wind generator to mast.
▪
Erect the mast.
▪
Align the mast vertically in all directions.
▪
Brace the vertical mast (see Fig. 5)
▪
Cancel short circuit.
Summary of Contents for ZEUS3.0
