8
Operation and Storage Manual
EN
electronic thermoregulator reduces the brightness
of illumination of all LEDs. Upon pressing any of the
buttons the brightness increases for 8 seconds and it is
then reduced again.
g.
If the display shows “t0” or “t1“, this means that the
self-diagnostic system has found a problem with the
temperature sensor. “t0” indicates a disconnected
cable at the sensor, while “t1” indicates short circuit
at the sensor. In this case the electric convector will
be automatically switched off and it can be switched
on again only after the problem has been fixed. The
problem has to be handled by a qualified specialist.
h.
Upon switching on the power supply the display
will show hyphens “----“ for 2 seconds instead of
temperature of time.
i.
When the digital display shows the temperature the
“Temperature” LED is lit, and when it shows the time,
the “Timer” LED is lit.
PROTECTION
•
The appliance is equipped with a safety thermo turn-
off device, which automatically turns the heater off in
cases of extreme temperature of the panel heater /i.e.
overheating of the appliance/.
•
The safety thermo turn-off device will automatically
restore the heater operation when the temperature
of the appliance falls below the permissible ultimate
values.
CLEANING
•
It is compulsory first to turn off the appliance
through its power switch and to disconnect it from
the power socket. Before starting the cleaning
session you should wait until the panel heater cools
down in a disconnected state.
•
The panel heater can be cleaned with little efforts at
the appliance rear part – just press the “P”-shaped
braces /figure 2/ at the back of the appliance so
that you can dismantle it and consequently you can
clean the rear part of the appliance.
•
Clean the heater body with damp cloth, vacuum
cleaner or a brush.
•
Never immerse the appliance into water – there is
danger for your life from electric shock!
•
Never use gasoline, thinner or hard abrasive
products to clean the appliance, because they will
damage the appliance coating.
STORAGE
•
Before putting the panel heater away let it cool
down after you have disconnected it from the
power socket
•
Use the appliance original packing to store it, if the
panel heater will not be in use for a long period of
time. By storing the product in its original packing you
protect it from excessive dirt and dust accumulation.
•
Never put a hot panel heater in its packing!
•
It is necessary the product to be stored at a dry and
dark place, protected from direct sun light.
•
It is explicitly forbidden to store the panel heater in
damp and wet premises.
MAINTENANCE OPERATIONS OF THE APPLIANCE
•
In case of appliance malfunction, please contact the
authorized service center closest to your location. /
service centers are indicated in appliance warranty
documents/.
•
Important
: In case of a claim and/or violation of
your consumer rights, please contact the supplier of
this appliance at the indicated locations or via the
Internet page of the company: www.tesy.com
DIMENSIONS OF HEATED VOLUME AND HEATED
AREA OF A ROOM / APPLIANCE MODELS
Model
Heated volume Heated area
CN024 050 EIS W
- 500W
10* - 15 m
3
4* - 6 m
2
CN024 100 EIS W
- 1000W
20* - 30 m
3
8* - 12 m
2
CN024 150 EIS W
- 1500W
30* - 45 m
3
12* - 18 m
2
CN024 200 EIS W
- 2000W
40* - 60 m
3
16* - 24 m
2
CN024 250 EIS W
- 2500W
50* - 70 m
3
20* - 28 m
2
* Minimum guaranteed heated volume (area) for heating at an average
capacity of heat transmission factor λ=0.5 W/(m
2
K) for a heated room.
Higher values of heated volume (area) can be achieved at an average
value of λ=0.35 W/ (m
2
K). Standard height of heated rooms – 2.5 meters.
Warning: Do not cover the appliance
in order to prevent overheating!
Environment protection instructions
Obsolete electric appliances contain valuable
materials and consequently they should not
be treated as domestic waste! We ask for your
cooperation and your active contribution to protect
the resources and the environment. Please submit
your out-of-use appliances to the organized buy-back
stations (if there are such).
