TET H2O-GSD4C, Installation & Operating Instructions Manual

INSTALLATION AND OPERATING INSTRUCTIONS 

H20-GSD4C

B. OPERATION INSTRUCTIONS

WARNING:

 Do not use with water that is microbiologically unsafe or 

of unknown quality without adequate disinfection before or after the 
system.

WARNING: 

Do not connect power until water 

fl

 ows from all taps

1. Wash all 

fi

 lter bottle parts (except 

fi

 lter cartridge) with warm water 

    and detergent and rinse thoroughly. In addition, 

fl

 ush clean water 

    through the unit and drain out via the taps and drain plug located 
    at the rear of the unit. Tilt the unit back and forth to remove 
    trapped water from unit. Continue this process until no more 
    water runs out of the drain.

2. Remove Filter Cartridge (1) from plastic, make sure not to lose the 
    

fi

 lter cartridge O ring. Immerse 

fi

 lter in ambient water for 20 minutes. 

    Shake 

fi

 lter under water to remove any excess black carbon 

    particles and trapped air.

Note: 

You may see small amounts of black particles at times; these 

are small pieces of carbon from the 

fi

 lter. These carbon particles are 

food grade and are not harmful. They will not impair the performance 
of your 

fi

 lter or unit.

3. Ensure drain plug (14) is secure on the unit and tighten in place.

4. Ensure that the Filter Bottle O ring (7) is seated in the channel 
    at the top of the cooling unit. See Figure 1 for location.

WARNING: If Filter bottle O ring (7) is not in place or correctly seated 
leaking may occur. When the 

fi

 lter bottle is removed special care 

must be taken to ensure this part is not lost. Always ensure the 0 ring is 
correctly seated prior to installing the 

fi

 lter bottle.

5.  Place 

fi

 ltered water chamber (6) onto the water cooler unit 

     and push down. There should be no gap between the cooling
     unit and the 

fi

 ltered water chamber (6).

6.  Lock the 

fi

 ltered water chamber (6) into position using the 

fi

 lter 

     bottle screw nut (15). Turn 

fi

 lter bottle screw nut (15) in a clockwise   

     direction. Tighten by hand only, do not over tighten. See 

fi

 gure 2.

7.  Place un

fi

 ltered water chamber (5) into the 

fi

 ltered 

     water chamber (6)

8.  Install Filter cartridge O ring (2) onto the un

fi

 ltered water 

     chamber 

fi

 lter thread then screw the 

fi

 lter cartridge into place.

9.  Pour water into the un

fi

 ltered water chamber (5) allow water 

     to 

fi

 lter through to the 

fi

 ltered water chamber (6)

INSTALLATION AND OPERATING INSTRUCTIONS

H20 GSD4C