Teufel MediaStation 6, Technical Description And Operating Instructions

49

 • MediaStation 6

6.2 Frequently Asked Questions

Question 1

. 

When I try to disconnect the 

USB device, I keep on getting “The device 
‘Generic volume’ cannot be stopped right 
now. Try stopping the device again later.” 
message, what should I do?

Answer: 

Close any program that might be ac-
cessing data on the player, including 
Windows® Explorer. If it does not work, 
close all programs and wait for another 
20 seconds, then try the green arrow icon 
again. If it still does not work, you should 
shut down the player and disconnect the 
USB cable.

Question 2

. 

I fi nd new fi le names and 

folder names that I never created before or 
they have strange gibberish names.

Answer:

Most likely, the player’s fi le allocation 
table (FAT) has been corrupted. This might 
be due to the player shutting down (due 
to low battery power) while reading or 
writing to your computer by the USB con-
nection. Windows and Macintosh often 
write extra fi les to the hard disk such as 
fi nder.def or System volume info. These 
are normal and will not do any harm to 
the player.

Question 3

. 

I used my player to transfer 

fi les back and forth between different com-
puters. Will defragmenting the player hard 
disk do any harm to it?

Answer: 

Defragmenting the player hard disk may 
be useful after having transferred many 
fi les to and from the player. It is never 
harmful to use the defragment on the 
player. Make sure no other programs are 
running while using the Windows® de-
fragment utility. Make sure you have con-
nected the player with the external power 
adapter during this procedure.

Question 4

. 

My fi les have disappeared 

from the player.

Answer: 

Make sure that you browse your fi les via 
the correct browser mode which means 
correct fi ltered views such as Photos, Mu-
sic, or Movies.

Question 5

. 

During power on, why does 

the TV will have a short fl ashing, blue 
screen or screensaver?

Answer:

This is normal, when the system initializes, 
it will setup the corresponding parameters 
so it can output the correct video signal to 
the TV, during the initializing time, the TV 
will receive incorrect signals or the signals 
will not be stable and will cause the TV 
screen to fl ash, some TV’s will treat this as 
no signal, and will display a blue screen 
or screensaver.

Question 6

. 

Why when I switch to Y/Pb/

Pr 480p, 576p, 720p, 1080i, and 1080p, 
does the TV screen display an unwatchable 
picture?

Answer:

Please check if your TV supports Y/Pb/Pr 
480p, 576p, 720p, 1080i, and 1080p 
output, if your TV does not support, please 
use the A/V signal display instead, press 
the TV SYSYEM button on the remote 
control, then switch the TV’s video input to 
NTSC or PAL.

Question 7

. 

Why is there no sound on 

movie or music playback when using Y/Pb/
Pr component output?

Answer:

Y/Pb/Pr output is a video output only, and 
does not include sound signals. When us-
ing Y/Pb/Pr output, please plug the A/V 
OUT or the S/PDIF jack to output sound.

91691 GB A5 20110901.indd   49

91691 GB A5 20110901.indd   49

01.09.11   15:10

01.09.11   15:10