4
• Transmitter Subconnect TX
For Your Safety
Proper use
The Subconnect TX is intended for re-
ceiving a mono analogue subwoofer
signal via an RCA cable and transmit-
ting it wirelessly to the subwoofer. The
Subconnect RX or another compati-
ble subwoofer from our assortment
can be used as a receiver.
Only use the Subconnect TX as
described in this instruction manual.
Any other use will be deemed as not
in accordance with the instructions
and may lead to damage of property
or even persons.
The manufacturer accepts no liability
for damage caused by improper use.
The Subconnect TX is intended for
private use.
Explanation of terms
You can find the following signal
terms in these instructions:
WARNING
This signal term indicates a
moderate risk, which, if not
avoided, may result in death
or severe injury.
CAUTION
This signal term indicates a
low risk, which, if not avoided,
may result in minor or moder-
ate injury.
NOTICE
This signal term warns you of
potential damage.
Safety notes
This chapter contains general safety
notes which you should always
observe to protect yourself and third
parties. Also observe the warning
notes in each chapter of this instruc-
tion manual.
Improper electrical installation
or excessive mains voltage may
result in an electrical shock.
• The enclosed mains adapter is
suitable for a mains voltage of 100
– 240 V ~ 50/60 Hz. When con-
necting the device, make sure that
the correct voltage is present.
• Only use the enclosed mains
adapter or a mains adapter with an
identical construction.
• Check the mains adapter regularly
for damage. Do not in any case use
a damaged mains adapter.
• Never open the housing of the
mains adapter.
• Only use the device indoors and
not in wet rooms. Protect it from
dripping and splashing water. Make
sure that no vases or other liq-
uid-filled containers are on or near
the device in order to prevent liquid
from penetrating the housing. If
