6
Activating and deactivating
• The subwoofer is activated or deactivated with the switch
10
“Power”. If the subwoofer is on, the LED
3
“Power” is
illuminated.
Automatic activation/deactivation
• Switch
2
„On • Auto“:
–
Auto
position: The subwoofer is automatically activated
as soon as an audio signal is present at the jack
7
“Line
In” (LED
3
“Power” is illuminated in green).
If there’s no audio signal for 20 minutes, the subwoofer
switches to standby mode (LED
3
“Power” is illuminated
in red).
–
On
position: The subwoofer is continually activated.
Changing the input sensitivity of the automatic activation
• You can change the sensitivity of the automatic activation
using the controller
5
“Auto Level”. This is helpful if the
subwoofer does not activate in spite of a present audio sig-
nal or if it is activated by glitches.
Use a small screw driver for turning the controller.
Volume
• You can control the volume of your subwoofer using the
volume control
6
“Volume”.
Phase
• You activate and deactivate phase shifting (180°) for the
subwoofer using the switch
1
“Phase”. Choose a setting at
which the subwoofer emits the loudest and most precise
sound.
Crossover frequency
• The subwoofer must be set to “On” in the bass manage-
ment/speaker management (“Speaker Setup”) of the AV
receiver. The appropriate crossover frequency to be set there
depends on the satellites being used. You can find specifica-
tions for the crossover frequency of the respective satellites
in the technical data section of our web shop.
10
1
3
5
7
6
2
Use
Clean the subwoofer regularly with a soft, damp microfiber
cloth. Please be absolutely sure to observe the following notes
in the process:
• If possible, only use plain water without any additives. In
case of stubborn marks, a mild soap solution may be used.
Danger
Risk of electric shock!
In contact with live parts, water can lead to electric
shock or short circuit.
• Make sure that no liquid penetrates the unit.
• Disconnect the mains plug before cleaning.
Cleaning and care
Attention
Risk of damage!
Using the wrong cleaning materials may damage
the delicate surface of the case.
If possible, only use plain water without any additives. In
case of stubborn marks, a mild soap solution may be used.
In no circumstances should caustic cleaning products, white
spirit, thinners, petrol or similar be used for cleaning.
