EVENT TENT BASIC
ASSEMBLY
ASSEMBLY HARDWARE
A.
B.
C.
D.
E.
DISCLAIMER: Tents should always be staked down with Premium Tent Stake Kit and weighed down. Tents should not be used in inclement
weather, including thunderstorms, heavy rains, lightning, and high winds. No grill or any type of open flame is to be used under or near the
tent. User must read and observe assembly instructions. If this is not done correctly, it may result in damage to the unit, injury, or death, and
all warranties will be void. All warranties will be void if hardware is used with any print not produced by us. Properly care for prints to keep
them in great condition. Prints should never be dragged along the ground or stored without being properly folded and free from moisture.
Make sure print is completely dried from any weather, and fold and store in a clean, dry place. We don’t recommend storing print on frame.
A.
Frame
B.
Carrying Case
*
C.
Middle Support Pole*
D.
Support Poles*
E.
Clamps*
*
Optional
Assembly Instructions
R1.042716
NOTE: It is recommended to use 2+
people for tent assembly.
1. Place the frame on the location chosen for assembly.
Make sure the feet of the frame are on the ground.
2-3. Expand the frame outward, but not fully, and place
the tent print over the frame. Make sure the print is
facing the correct direction and that the corners of the print
line up with the correct corners of the frame.
4. Attach the loop adhesive, located on the inside of the print,
to the hook adhesive around the top of the main posts.
5-6. Completely expand the frame outward. The locking
clips will snap into place to indicate full expansion of
the frame.
7. Pull up the legs of the frame to the desired height,
making sure the locking clips snap into place. Standing
and using your foot to hold down the tent foot makes this
step easier.
8. Extend the canopy to its full height by using the rooftop
crank adjustment. This will also tighten the print for a
wrinkle-free display.
NOTE: Remove print prior to collapsing and storing the
frame. Do not store the frame with the print
attached. Treat printed canopy with care to
avoid scratching.
1.
3.
5.
7.
8.
6.
4.
2.
