28
Step 6:
Attach the Log Cradle
1. Attach log cradle (#53) to the
beam using hex bolt M10x35
(#129) and hex lock nut M10
(#114). The tightness is
appropriate for log cradle rotation.
Step 7:
Add Engine Oil
1. Make sure the log splitter is on a level surface.
2. Remove oil fill cap to add oil.
3. Refer to the separate owner’s engine manual for the amount needed of SAE10W-
30 engine oil; replace oil fill cap/dipstick.
4. Check engine oil level before use and add if needed.
NOTE: During the break-in period check the engine oil level often.
Step 8
Add Gasoline to the Engine
1. Use only clean, fresh, regular unleaded fuel with a minimum 86 octane rating.
2. DO NOT mix oil with fuel.
3. Remove the fuel cap and slowly add fuel to the tank. DO NOT overfill allow
approximately ¼ inch of space for fuel expansion.
4. Screw on the fuel cap and wipe away any spilled fuel.
