11
Battery and charger
Warning:
Do not try to disassemble, short circuit or put
it to extreme heat or fire, as it can cause serious inquiry
and permanent damage to the battery!
Important:
To protect the battery from total
discharge, the machine will stop, when the battery is
nearly empty.
The machine must not be started up again after
automatic shutdown, as it can damage the battery.
The battery must be recharges before the work can
continue.
Charging
•
Only use the original charger which is included.
•
Before the battery is being used the first time, it is
recommended to fully charge it first.
•
Do not try to charge other type of batteries in the
charger, other than the original battery.
•
Keep the charger in a dry and warm environment
(10-25 degrees C) and only use it indoor. It should
be connected to a normal 230V AC socket.
•
The surface of the battery can become warm
during charging. This is normal.
•
Do not cover battery or charger during charging.
Allow free ventilation of air.
A fast charger is included with the machine. A full
charge takes around 60 min.
Charging step:
1. Check that your mains voltage is the same as that
marked on the rating plate of the battery charger.
Insert the power plug of the adapter into the mains
socket outlet. The LED (b) on the adapter will turn
green.
2. Insert the battery pack into the charger pedestal
(c). The LED will turn red at once. It’s means the
charger is working.
3. After the completion of charging, the LED will turn
green.
Attention:
Removebattery from the charger,during storage.
Avoid water/moisture near the charger.
Important:
The charger will stop, when the battery is
full. However, it is not recommended to leave the
battery in charger for more than 24 hours.
It is recommended to drain the battery completely and
fully charge it whenever possible, as it can increase
the health of the battery. But partial charge will not
damage the battery.
Storage
Clean the machine after use. Make sure no debris gets
in through the cooling slots of the motor housing. Store
the cleaner in a frost free area, out of reach of children.
During winter storage, the battery should be fully
charged and kept warm at 10-20 degrees C. Charge it
every 3 months. Make sure to keep ventilation holes
clean and free from dirt.
Store the charger indoor between 5-25 degrees C.
Specifications
Model
WR1080
Battery voltage
10.8 V
Brush speed
1200 /min
Brush size
100 mm
Net weight
2.4 kg
Battery type Lithium-ion
Battery capacity
1.5 Ah
Charging time
Approx 1 hour
Operate time
About 20 min.
Charging unit
220-240 V~/ 50-60 Hz
Warranty terms and conditions
The warranty period is 2 years for private end users in
EU countries.
Products sold for commercial use, only have a warranty
period of 1 year.
The warranty covers material and/or fabrication faults.
Normal wear and replacement of wearing parts are
NOT covered by the warranty.
Wearing parts, which are NOT covered for more than
12 months:
•
Brushes
•
Wheel
•
Guards
•
Battery: If the battery is not stored correct (frost-free
and recharged every 3 months), the durability is
only guaranteed for 6 months.
The warranty does NOT cover damages/faults caused
by:
•
Lack of service and maintenance
•
Structural
changes
•
Exposure to unusual external conditions
•
Damages to the bodywork, protection guards,
panels etc.
•
If the machine has been improperly used or
overloaded
•
Use of unoriginal spare parts.
•
Other conditions where Texas cannot be held
responsible.
* We reserve the right to change the conditions and
accept no liability for any misprints
