19
Resetting Cycle Count
To reset the heat seal machine’s Cycle Time A count, perform the following while the control
panel is in Monitoring Mode:
1.
Press and release the Cycle Time A button.
2.
Press and hold the Cycle Count button. After approximately two seconds, the panel’s
button will light and the Cycle Count button blinks, as shown in Figure 9-1. This
puts the control panel in Set Mode. Release the Cycle Time button. The control panel
displays the current cycle count.
Figure 9-1
Resetting the Cycle Count
3.
Press and release the
button to decrease the completed cycle setting by one (1).
To reset the value immediately to zero (0), press the
button and hold it down.
4.
Press and hold the
button to reset the “short” cycle count to zero (0).
5.
After you reach the cycle count that you want, press and release the Cycle Count button
again to save the setting and return the control panel to Monitoring Mode.
Summary of Contents for DES-32
Page 1: ...Heat Seal Machine DES 32 Texas Automation Products Inc 300 Nichols Drive Hutchins TX 75141 ...
Page 22: ......
Page 23: ......
