5
Chapter 2: Installing the DES-32
This chapter provides instructions to help you unpack the DES-32, check that you have all the
components, and make the hardware connections. Perform the installation procedures in the
order in which this chapter presents them.
Unpacking and Inspecting the DES-32
To remove the DES-32 from the shipping crate, you need the following tools:
A knife or suitable sharp instrument
A ½” socket wrench or suitable tool
Cut the cardboard box where it joins the skid. With the socket wrench or other suitable tool,
remove the four bolts that secure the DES-32 to the skid. Carefully lift the DES-32 from the skid
and remove all other materials from the shipping crate.
You should have all of the following items:
The DES-32 pneumatic heat seal machine
The package in which you found this operations manual
Locating and Securing the DES-32
Before connecting electricity and air, locate the DES-32 heat seal machine where it will be
operated. Choose a location that provides the electrical and compressed air requirements.
Electrical and Compressed Air Requirements
120 volt, 60 Hertz power supply
25 PSI minimum / 120 PSI maximum, .050 Cu. Ft. free air per cycle
Summary of Contents for DES-32
Page 1: ...Heat Seal Machine DES 32 Texas Automation Products Inc 300 Nichols Drive Hutchins TX 75141 ...
Page 22: ......
Page 23: ......
