17
14. Trouble shooting
Engine will not start
•
Check if follow correct start procedure
•
Check that On/Off switch is set to I” (ON)
•
Wrong choke position (cold vs. warm start)
•
Adjust carburetor (contact service center)
•
Spark plug is not connected properly
•
Clean/replace spark plug
•
Clean/replace fuel filter
Engine starts, but runs on lower speed
•
Wrong choke position – Set choke to
•
Clean/replace
airfilter
Motoren kører ujævnt / Ingen motorkraft
•
Wrong choke position – Set choke to
•
Spark plug is not connected properly
•
Clean/replace spark plug
Motoren ryger meget
•
Wrong choke position – Set choke to
•
Wrong fuel mixture
Please note that any interventions that exceed ordinary
customer-level maintenance and require separation of
the product housing must be performed by qualified
personnel. If this work is performed by persons without
the proper qualifications, the right of complaint will
lapse.
15. Warranty terms and conditions
The warranty period is 2 years for private end users in
EU countries.
Products sold for commercial use, only have a warranty
period of 1 year.
The warranty covers material and/or fabrication faults.
Restrictions and requirements
Normal wear and replacement of wearing parts are
NOT covered by the warranty.
Wearing parts, which are NOT covered for more than
12 months:
•
Cables
•
Switches
•
Membranes/gaskets
•
Spark
plugs
•
Engine liquids (oil, gasoline, grease)
•
Starter
cords
•
Filters
•
Collector
bag
The warranty does NOT cover damages/faults
caused by:
•
Lack of service and maintenance
•
Structural
changes
•
Exposure to unusual external conditions
•
Damages to the bodywork, deck, handles, panels
etc.
•
If the machine has been improperly used or
overloaded
•
Wrong handling or storage of the battery
•
Use of unoriginal spare parts.
•
Other conditions where Texas cannot be held
responsible.
Whether a case is a warranty claim or not is
determined in each case by an authorized service
center.
Your receipt is your warranty note, why it should
always be kept safe.
REMEMBER:
The purchase of spare parts as well as
any request for warranty repair, art. number (e.g.
900631XX), year and serial number should always be
informed. It can be found on the CE-label located on
the rear discharge guard!
* We reserve the right to change the conditions and
accept no liability for any misprints
Summary of Contents for GBV 270
