www.texas.dk
9
Sweeper MS950 with integrated collector box is an effective manual sweeper, which is easy to
operate and it can be used on all hard surfaces – both outdoor and indoor..
The unique sweeping system with round brushes guarantees a good cleaning.
To ensure the best result with your sweeper, please follow these instructions.
Assembling
Fig 1:
Remove the container and cut the cable tie.
Lift the arm and align the holes, insert the tube and block both sides. Note: When you take off
the arm, don’t remove the belt or rotate the arm. It may cause the belt to turn wrong.
Fig 2:
Make the belt into the example 1 and put down the arm. And make the belt into the
example 3.Then push the manual sweeper and make sure the rotation direction of the turntable
is same as the label. Note: To avoid confusion, install one side and then install the other side.
Fig 3:
Install the container and lock it. Then install the handle.
Fig 4:
According to the label on the front brush to distinguish the left and right side brush.
Three screws to set up each side brush.
Fig 5:
Main brush adjusting handle, turn right to lower brush; turn left to lift brush.
Fig 6:
Front brush adjusting handle, turn right to lower brush; turn left to lift brush.
How to operate the sweeper
The sweeper is adjusted for plain surfaces (The cleaning surface should be competitive flat and
height difference max. 2.5cm. Fig 7) The brush pressure can be adjusted by turning the knob on
the main and front brush adjusting handles. Try different positions to find the best setting on the
surface you will use the sweeper on (different surfaces might require different brush pressure).
Adjust the height and angle of handle for need (Fig. 7+8)
Make sure that the brushes are only being pressed softly towards the ground.
A hard pressure will not make the cleaning result better, it will only cause wear to the
brushes much faster.
Push the sweeper in normal walking speed. If the dirt/rubbish is being pushed in front of the
brushes, some fast movements forward (faster speed on brushes) might help to collect the
material.
The round brushes which works in a flat horizontal position, are mainly designed to collect leafs,
twigs, stones and larger items. It can however also sweep up dust and grit, but this
might leave a small line in the middle. This is simple to overcome by overlapping on the next
pass, then most of it will be collected.
It cannot be entirely avoided, that small leftovers of dust/dirt remains after using the sweeper.
The result depends of the material the sweeper has to collect and the surface of the floor it is
being used on. This sweeper is designed to sweep up small and bigger dirt/rubbish, it does not
vacuum like a vacuum cleaner. m
How to empty the collector box
Open metal button then pull back to unload back container.
Turn metal knob and lift to unload front container.
To open the collector box, pull the handle up on top of the collector box.
After emptying the box, put it back in place and lock the handles
Make sure the edges is placed correctly before the handle is being locked.
