13
4. Mounting
Unpack all parts and display them as below.
A:
Main frame and electric motor
B:
Protection shield
C:
Blade
D:
Holder
D:
Support
Not shown :
Blade protection shield
Assemble the saw as shown in illustration:
1.
As
semble the part ”D”, as shown, with the enclosed bolts and nuts.
2.
Uplift the holder
”D” up like shown. At the same time, the protection shield ”B”
should be placed on the engine.
3.
Fix the protection shield to the engine with the 3 bolts.
4.
Put the inner flange of the blade saw to the engine output shaft Place the paper
washer up against the flange.
5.
Put the saw blade to the engine output shaft.
Place the paperwasher up against the blade.
6.
Put the outer flange of saw blade to the engine output shaft and screw the nut on.
And tighten the nut with wrenches.
7.
Fix the saw blade outer protection shield, using 3 long bolts.
8.
Fix the switch to the back of the engine as shown on pictures, using 4 bolts.
9.
Connect the support chains to the main frame.
10.
Assemble the support 1 and 2.
B
A
C
D
E