3. Connect the mini-USB cable to the TSW1400EVM (J2).
4. Connect the mini-USB cable to the
(J19).
3.5 Connect Signal Generators to ADC3541EVM
Connect a signal generator to the clock input at J2. Set the frequency to 10 MHz, and amplitude to +10 dBm. By
default, the clock signal is converted from single-ended to differential by transformer T1.
Connect a signal generator to the analog input at J11. A 2.2-MHz sine wave input at +15 dBm is used in this
example. Use a bandpass filter for best results. By default, back-to-back baluns are used to convert the single-
ended input to differential.
3.6 Configure HSDC Pro and Capture Data
Use the following steps to configure the HSDC Pro and Capture Data
1. Open the HSDC Pro Software
2. Click the
OK
button to confirm the serial number of the TSW1400EVM
Figure 3-2. HSDC Pro: TSW1400EVM Acknowledgment
3. Select
ADC3543_14W_14bit_SDR
from the ADC select drop-down in the top left corner
4. When prompted, click the
Yes
button to update the firmware
5. Enter “10M” in
ADC Output Data Rate
Setup Procedure
SBAU294 – JULY 2020
ADC3541EVM Evaluation Module
5
Copyright © 2020 Texas Instruments Incorporated
