ADS1115EVM-PDK Kit Operation
6.2
Setting Up the ADS1115EVM-PDK
The ADS1115EVM-PDK contains both the ADS1115EVM and the MMB3 motherboard; however, the
devices are shipped unconnected. Follow these steps to set up the ADS1115EVM-PDK.
Step 1.
Unpack the ADS1115EVM-PDK kit.
Step 2.
Set the switches on the MMB3 as described below, as
illustrates.
•
Set switch SW4 to the right.
•
Set the DAC switch (SW5) to the OUT position (to the right).
Figure 4. MMB3 Switch Locations
8
ADS1015EVM, ADS1115EVM, ADS1015EVM-PDK, and ADS1115EVM-PDK
SBAU157B
–
August 2009
–
Revised May 2011
Copyright
©
2009
–
2011, Texas Instruments Incorporated