Connecting bq76PL536PGM-1 and bq76PL536EVM-3 Boards
3
Connecting bq76PL536PGM-1 and bq76PL536EVM-3 Boards
3.1
Connecting bq76PL536EVM-3
See the bq76PL536EVM-3 (
) User's Guide.
Figure 1. bq76PL536EVM-3
3.2
Connecting bq76PL536PGM-1
Figure 2. bq76PL536PGM-1
1. Connect the USB cable to the Aardvark adapter and your PC.
2. Connect the Aardvark ribbon cable to the 10-pin header on the bq76PL536PGM-1 programmer board.
3. Run the bq76PL536A OTP EPROM programmer software on your PC.
4. Check for 22-V and 7-V LEDs on the board and GUI. See
5. If all of the LEDs are not ON, select Connect to Dongle (F2), or repeat the preceding steps.
3
SLUU468A – December 2010 – Revised July 2015
bq76PL536PGM-1 Programming Board
Copyright © 2010–2015, Texas Instruments Incorporated
