Getting Started
Figure 7. LED BoosterPack With C2000 LaunchPad and MSP430 Capacitive Touch BoosterPack
4.2.1
Hardware Setup for Capacitive Touch Demo
Perform or verify the following steps to prepare the LED BoosterPack for use with the MSP430 Capacitive
Touch BoosterPack.
1. Verify the following jumper and switch settings on the LED BoosterPack:
(a) A jumper is not placed on J2.
(b) A jumper is not placed on J8.
(c) The switch S1 is in the up position.
2. Verify the following jumper and switch settings on the C2000 LaunchPad:
(a) A jumper is placed on JP1.
(b) A jumper is placed on JP2.
(c) A jumper is placed on JP3.
(d) Switches in S1 are all in the up position.
(e) The switch S4 is in the down position.
3. Insert a C2000 LaunchPad into the header marked J3, J9 and J4, J10 on the LED BoosterPack.
4. Insert an MSP430 Capacitive Touch BoosterPack onto the headers marked J6 and J7.
5. Connect the LED BoosterPack to the included power adapter and plug in the adapter to the mains
power.
6. Connect the LaunchPad to the PC using the USB cable included with the C2000 LaunchPad.
11
SPRUHH9 – July 2012
C2000 LED BoosterPack
Copyright © 2012, Texas Instruments Incorporated
