RadioShack parts list for BCC deluxe
18.57
Total cost:
0.15
278-1310
4-conductor 24GA solid
phone cable, 1 foot
Hook-up wire
1.99
274-245
3/32" female jack
1.49
64-3018
4-40 hex nuts
1.49
64-3011
4-40 machine screws
2.19
276-1381
10 mm
Stand-offs
2.29
270-1802
4" x 2" x 1"
Enclosure
1.29
276-1538C
DB9 female connector
1.19
276-150
Printed-circuit board (PCB)
0.49
276-1342 (pack of 5)
47kohm, 1/8W, 10%
R5, R6
0.49
276-1347 (pack of 5)
100kohm, 1/8W, 10%
R1, R2, R3, R4
2.36
276-2023
PN2907
Q3, Q4, Q6, Q7
1.96
276-2058
2N4401
Q1, Q2, Q5, Q8
1.19
276-1122 (pack of 10)
1N914/1N4148
D1, D2, D3, D4
Total cost US$
RadioShack part number
Value
Designator
All of these parts should be in stock at any RadioShack, but your particular RadioShack may have to
order some of them. Also, prices may vary slightly from store to store. The 4-40 machine screws and
nuts are used to mount the DB9 connector to the enclosure. The individual wires of the phone cable
are used for jumper wires on the PCB. Considering that the component cost is about $19, and you can
buy the TI cable for $20, you aren't saving much money. However, much of the cost is in the enclosure
and mounting hardware. You can save some money by using creative alternatives.
This figure shows one possible component layout on the 276-150 PCB:
5 - 7
Summary of Contents for TI-92+
