Note also that most other GraphLink operations work with either calculator; for example, the screen
grab and calculator backup and restore functions work correctly, regardless of which calculator is
actually connected.
[5.10] Run GraphLink under Windows XP
Various visitors to TI's discussion groups have shared their tips on getting the Graph Link and TI
Connect software running under Windows XP.
John Gilbertson notes that Microsoft has acknowledged a problem with .vxd files running in Windows
XP. During setup of the link software, do not indicate that you are using a black Graph Link cable, as
this will install a .vxd file and screw things up. Run the software once using the grey Graph Link cable
setting, then you can change it to the black cable and it should work.
Joseph Thornton reports that TI Connect and the Graph Link software work in Windows XP if they
are set to run in Windows 98 compatibility mode. To do this, go to the location where the program is
installed (usually C:\Program Files\TI Education\TI Connect\) right-click the program executable file
(i.e. TIConnect.exe) and click properties, then click the Compatibility tab, then click "Run this program
in compatibility mode for Windows 98 / Windows ME", then check the "Disable Visual Themes" box,
and finally click OK. Repeat for all the .exe files in the TIConnect folder.
Mr. Thornton also reports that as of this writing (Feb '02), the USB Graph Link cable doesn't work
under Windows XP. He suggests using TiLP instead if you have too many problems with TI Connect.
Bill Gorder reports success by running the program executable file from a command prompt (DOS)
box.
Andrew Farris reports that Windows XP has a problem running 16 bit programs that are too many
directories deep. He installed the link software to C:\Program Files\TI\ instead of C:\Program Files\TI
Education\TI-Graph Link 89\ and it worked for him.
(Credit to Ray Kremer)
[5.11]
Improve font size of printed program source code
Cass Lewart sends this tip to get more readable source code print-outs from TI Connect. It also works
with TI GraphLink.
"Printing a program with TI Connect (File/Print) results in a very small font, which cannot be changed.
However, pasting the program into, e.g., Word (From TI Connect File/Open/Select All/Copy) then
opening Word and Paste gives many more options. It requires selecting TI92Pluspc or one
of the other scalable TI fonts which are installed on the desktop during TI Connect installation. These
fonts have a full range of sizes, bold or italic."
Obviously the same technique works with any word processor or page layout program.
(Credit to Cass Lewart)
5 - 16
Summary of Contents for TI-92+
