19
Texas Instruments Robotics Systems Learning Kit: The Maze Edition
SWRP249
Gather:
-
Prepared Chassis
-
Plastic Standoffs (h)
-
Screws #4-40
1/2” (g)
-
Nuts #4-40 (j)
Attach the standoffs (h) to the top
of the chassis with screws (g) from
the bottom via the highlighted
areas above. Do not over tighten
or screw them all the way in.
You will use four nuts (j) to
attach the LaunchPad
after the next section.
Note:
the chassis holes
may be slightly too small,
but the screws will fit.
Press the screws firmly
through.
Step 7: Attach LaunchPad Standoffs